Bootloader and edison image


I tried once again to flash the boot loader and following the instructions didn’t help. No where in the instructions does it say to apply power to the robocore board, it only said to connect the pc to the mini USB port.

After applying power to the robocore I was able to successfully flash the boot loader. After the boot loader was installed I removed the Edison from the robocore and fitted it to the Edison breakout to install the new image, this also completed successfully so everything was looking good.

I then reinstalled the Edison into the robocore board and rebooted it. I also though it was a good idea to reinstall the husarion app from the app store in case this had been updated.

Now the issue I have is the only things the app finds is my tv and my iwatch.

Would appreciate any suggestions you can offer.