Rosbot XL (Jetson Nano): Problem updating SBC, How to Start instruction issue

[RafalGorecki]

Hello @avillaj88,
it seems to me that a similar issue was recently discussed in this thread.

Rosbot-XL (Jetson Nano) - Quick Start (snap) freezes the system

Hi, It seems that there is an issue with Snap on Ubuntu 18. The current solution is to check out a pre-Snap commit on the robot-config repo. The rest of the setup guide remains the same. Could you try this block of code instead of the one specified in the guide? git clone https://github.com/husarion/robot-configs cd robot-configs git checkout 47f1309 cd .. sudo ./robot-configs/install.sh rm -rf robot-configs sudo setup_robot_configuration rosbot_xl ros2_humble If the issue persists, please l…

I would like you to read it and let me know if the problem has been solved.